The following ‘AT’ commands are utilized in the CONNECT software to communicate directly with the internal modem. These commands can be used to setup and troubleshoot the internal modem settings. Review the following article to establish communication with the internal modem and send the proper commands for setup: CONNECT Cell Terminal AT Command Description Example […]
Articles Tagged: Knowledge Base Software
Communicate Directly with an SDI-12 Sensor
In CONNECT’s X2 Diagnostic feature, users can communicate with and send commands directly to a connected SDI-12 sensor (V2.22.03.03 or later firmware). Direct communication is critical for confirming sensor transmission, determining the sensor’s SDI-12 address, and reviewing the parameter output. Communicate with an SDI-12 sensor through common SDI-12 protocol commands by following the process below. […]
Access the Data Export Tool
The Data Export feature is a quick and simple data acquisition tool that allows users to download or send data through email or FTP in CSV or multiple XML formats without loading data directly onto the WQData LIVE page. This feature removes the latency associated with loading a substantial data set. To access the […]
Set Log and Transmit Start Times
The log start time and selective upload interval(s) can be set through the Advanced Device Remote Configuration tool. These features allow the X2 to log data to its internal memory at a specific log start time and control the transmission of certain parameters. These features help reduce system data usage and telemetry on-time. Adjust […]
Update Data Logger Settings
For proper transmission, the internal data logger settings must match the settings on WQData LIVE. Multiple commands will achieve this purpose depending on the telemetry model of the logger. Both commands can be accessed from the Advanced Device Remove Configuration Tool within the administrator settings. The Sync settings command applies to Wifi and cellular telemetry […]
Accessing the Advanced Device Remote Configuration Tool
The Advanced Device Remote Configuration tool allows the user to adjust the following: Update data logger settings Set the log and transmit start times Change which parameters are logged and transmitted Change the data logger transmission settings To access the tool: Navigate to the ADMIN | Settings tab found at the top of the project Dashboard. […]
Averaging Logged Sensor Data
Averaging for sensor parameters may be enabled by adjusting the log and sample intervals in the Device Remote Configuration Tool within the administrator settings. Log Interval: Frequency of data written to the data logger memory to be transmitted to the web. Sample Interval: Frequency of data read from the sensor by the data logger internally. […]
Accessing the Device Remote Configuration Tool
The Device Remote Configuration Tool allows remote configuration of the following: Change sensor logging and transmit intervals Configure event based transmissions for G2 and V2 systems Choose which parameters are logged and transmitted to the web Configure parameter offsets Name a data logger Run a sensor detection Sync X2 data logger settings To access […]
Enable Iridium Communication on an X-Series Data Logger
Satellite/Iridium transmission is more expensive than other traditional forms of communication (e.g., cellular, radio, Wi-Fi). Therefore, it is imperative that the end-user only transmit the most useful diagnostic and sensor parameters. The CONNECT software can set these parameters before the data logger transfers data to the web, thus reducing the overall data transfer. If a […]
Communicate with WQData LIVE through CONNECT
CONNECT contains commands to immediately communicate with the WQData LIVE web datacenter in the WQDATA tab. Options are available for updating the X2’s sensor configuration, checking and executing commands from the WQData LIVE command queue, and posting all stored data that has not yet transmitted to the web data center. Setup WQData LIVE Connect the X2 […]