Following a sensor detection, all diagnostic and sensor parameters are enabled for logging to the on-board micro SD card and transmission to WQData LIVE via the X2’s on-board telemetry. However, disabling transmission of individual parameters is possible. Disabling transmission of un-needed parameters is sometimes desirable to minimize the amount of unnecessary data sent. This is […]
Articles Tagged: Knowledge Base
Tag new knowledge base for search
Setting Rain Alerts
A separate section of the WQData LIVE Alarm tool allows G2-RAIN users to configure Rain Alerts. When triggered, such alerts notify project personnel that a rain event has occurred. Access this feature by navigating to ADMIN | Alarms at the top of the Project Dashboard. Expand the Rain Alerts section by clicking on the […]
Configuring Event-Based Transmission (G2/iSIC V2 Only)
Cellular G2 and iSIC V2 systems allow configuration of increased transmission frequency when a recorded parameter exceeds a user-defined threshold. This event-based transmission enables the system to upload data infrequently and minimize power and data consumption during normal operation, yet increase the frequency of logging and transmission of data during critical events. To configure event-based […]
Adjusting the Dashboard Map
The WQData LIVE Dashboard Map feature is an aesthetic and informative addition to the Dashboard display. The map gives the user a visual of the area surrounding the data logger, allows GPS-equipped loggers to be tracked, and contains visual updates to indicate triggering of system alarms. Map Features Click anywhere on the map to […]
Managing Quick Alert Notifications
The Quick Alert feature offers a quick method of configuring email/text message* notifications to send when an individual parameter crosses a basic threshold set by the user. While an alert is active, emails will repeatedly send for each uploaded reading that exceeds the parameter threshold. This feature is useful when using the more advanced Alarm […]
Setting Alarms
The Alarm feature offers an advanced method of configuring email notifications for parameter measurements. Alarms trigger based on one or more user-defined conditions established in the alarm configuration. Setting Alarms in Administrator Settings The ADMIN menu allows the user to activate alarms or quick alerts that notify project personnel any time that a certain parameter crosses […]
Install a SIM Card in an X2-SDL Submersible Data Logger
Statically ground yourself prior to touching any of the electronics inside the X2-SDL logger. Tools Required: – 3/16″ Ball-Point Hex Driver (included in logger maintenance kit) Use the 3/16″ hex driver to remove the four screws on the bottom bulkhead of the X2-SDL (opposite the white battery lid). Carefully pull the bottom bulkhead off […]
SP32 Solar Power Pack – FAQ
SP32 Resource Library
Drawings Quick Start Guide FAQ How To Warranty Service Request
UW-6 Power Bulkhead Connector Assembly Wiring
CB-Series Buoys supplied with a CB-PTL Pass-Through Lid for integration of user-supplied electronics include a UW-6 power bulkhead connector (UW6-BULK) port on the lid. The UW6-BULK connects to the solar tower on the outside of the buoy and has bare wires with Molex connector on the inside of the data well. Information regarding the port […]