Before a PC can begin to receive real-time data from the iSIC, a RS-232 Direct Connect Cable must be connected into the iSIC enclosure.

Important: Always remove power from all NexSens communications devices when wiring to the iSIC.

NexSens supplies a variety of permanent RS-232 Direct Connect Cable lengths ranging from 25 ft to 250 ft. For stand alone applications without continuous real time connections, the supplied A72 RS-232 Direct Connect cable may be used to communicate with the iSIC. This cable simply requires connecting the iSIC DB9 connector to the PC COM port.

table258

Figure 1: Connect iSIC DB9 connector to COM port

 

For real time connection to the data logger, A60-A64 Cables will need to be used. If an MS3 connector is located on the outside of the iSIC enclosure, simply connect the MS3 connector on
the A60-A64 DB9 to MS3 cable to the MS3 connector located on the iSIC and the DB9 connector to an open COM port on a PC running iChart software.

iSIC enclosure

Figure 2: iSIC Enclosure, MS3 is bottom middle

 

MS3 to DB9

MS3 DB9

Figure 3: MS3 to DB9

 

Color

MS3

DB9 Pin

Signal

Green

A

5

GND

White

B

2

Rx

Blue

C

3

Tx

 

If an MS3 connector is not available, an A60-A64 DB9 to flying lead cable can be used.

Wiring a direct-connect cable using a flying lead dongle, BTX: CD-MX9M

A direct RS-232 or RS-485 connection to the iSIC can be run through the DB9 port with a BTX CD-Mx9M dongle.

BTX Dongle

Figure 4: BTX CD-DB9FST Dongle

For RS-232 connection using the iSIC direct connect cable, the following pins are used:

ColorDongleDB9-MSignal
WhiteTerminal 2Pin 2Tx (iSIC to PC)
BlueTerminal 3Pin 3Rx (PC to iSIC)
GreenTerminal 5Pin 5GND

 

For RS-485 connection using a supplied cable, the following pins are used:

DongleDB9-MSignal
Terminal 5Pin 5GND
Terminal 6Pin 6RS485A
Terminal 8Pin 8RS485B

 

Secure the  dongle to the iSIC DB9 port. Be sure to tighten the screws with a screwdriver.

BTX Dongle2

Figure 5: Tighten dongle with screwdriver

 

 REV: 13J18

 

Leave a Reply

Your email address will not be published. Required fields are marked *