S500 Wave Sensor SD Card Access

    In order to access the raw data or update firmware on a S500 Wave Sensor the SD card must be accessed. Disconnect the UW8 connector from the logger. Remove the sensor from its mounting┬áby removing the two 1/4″ hex screws using a 3/16″ hex wrench Place the S500 on a dry and stable surface. Remove […]

    Read More

    S500 Inertial Wave Sensor

    Overview The S500 wave measurement system integrates a high accuracy inertial sensor to capture wave motion with next generation electronics for data storage and processing. The S500 internal Inertial Measurement Unit (IMU) employs three gyroscopes, three magnetometers, and three accelerometers to provide raw motion data acquisition with 6-degrees of freedom. The powerful on-board ARM microcontroller […]

    Read More