Identify the 6-pin power source cable located at the bottom left hand side of the iSIC-V2. Turn the connector bushing counter-clockwise until it is free from the port. Gently pull back on the power cable to remove it from the logger port and wait at least 30 seconds. Align the pins and […]
Articles Tagged: Legacy
Configure a Control Output on an iSIC-V2
Materials Required iSIC-V2 Firmware V8.02.14 or greater PC with iChart Software V6.20.021 or newer Serial Cable with USB Adapter Process Launch iChart and open the current project (.icr ) file for the system. Right click on the logger in the Navigation Panel, select Property. Connect a serial cable to the iSIC-V2 logger and select the […]
Install a SIM Card into an X2 Data Logger
While it is always recommended that a SIM card be sent to NexSens for installation prior to shipment, in some cases it may be necessary for an end user to install a SIM card. Caution!!!- Be sure to statically ground yourself prior to touching any of the electronics inside the X2 logger! Tools Required […]
G2-RAIN Alert System Data Logger – FAQ
G2-EXO Data Logger – How To
Mount a G2-EXO
iSIC-V2 Environmental Data Logger – How To
Establish Connection to an iSIC-V2 in Tera Term Cycle Power on an iSIC-V2 Data Logger Configure a Control Output on an iSIC-V2 Configure iSIC-V2 Ethernet Settings Install a SIM Card into an iSIC-V2 Program with iChart and configure for direct WQData LIVE posting Set an APN on a Cellular iSIC-V2 Replace the SD Card within […]
iSIC-V2 Data Logger – FAQ
What is the signal pinout of a NexSens 8-pin sensor cable? What is the signal pinout of the iSIC/SDL-V2 sensor port? What is the pinout of the iSIC/SDL-V2 UW6 power port? What are common terminal commands for the iSIC/SDL-V2?