The X2-SDLMC sensor ports are labeled to outline the Universal Asynchronous Receiver Transmitters (UARTs) available on the data logger. The sensor ports on the logger are engraved with Sensor 1 and Sensor 2. These ports correspond to the traditional P0 (Sensor 1) and P1 (Sensor 2) ports on other X2 data logger models.
Articles Tagged: Legacy
What is the X2-CBMC sensor port layout?
The X2-CBMC sensor ports are labeled to outline the (4) Universal Asynchronous Receiver Transmitters (UARTs) available on the data logger. These locations are critical to note for sensor detections; however, harsh deployment conditions may remove these labels. The following schematic outlines the sensor port’s location in relation to the vent, antenna, and 6-pin solar/com port. […]
What is the X2-CB sensor port layout?
The X2-CB sensor ports are labeled to outline the (4) Universal Asynchronous Receiver Transmitters (UARTs) available on the data logger. These locations are critical to note for sensor detections; however, harsh deployment conditions may remove these labels. The following schematic outlines the sensor port’s location in relation to the vent, antenna, and 6-pin solar/com port. […]
TriOS Wiring for Connection to an X2 Data Logger
This article serves as a guide for wiring in a TriOS NICO UV Nitrate sensor and a W55 wiper for connection to an X2 data logger. This configuration typically occurs with a NexSens A50 Junction Box to protect all flying lead cables from environmental disturbances. TriOS Sensor and Wiper Wiring TriOS M12 to bare wire […]
CB-25 Data Buoy – FAQ
CB-25 Data Buoy Resource Library
Datasheet How To FAQ Warranty Service Request
What sensor scripts are available on X-Series loggers?
X-Series loggers come pre-loaded with scripts for a host of environmental sensors that communicate over standard protocols such as SDI-12, NMEA0183, RS-232, and RS-485 Modbus. The entire script list is visible within the CONNECT software; however, only a few are enabled by default. Before running a sensor detection, it is imperative to review this default […]