iChart has the ability to run in Report Mode. While in this mode, iChart is only capable of viewing reports.

1. Close iChart if it is open
2. Right-click on Start | All Programs | NexSens | iChart6 | iChart.exe

Figure 1: Opening the properties dialog box


3. In the properties dialog box that appears, change the target from:
“C:/Program Files/NexSens/iChart6_ichart.exe” to
“C:Program Files/NexSens/iChart6/ichart.exe” –report only

Note: The “_” before ichart.exe must be removed

Figure 2: Altered target information

4. Click OK

5. Open iChart

Figure 3: iChart in Report Mode (REPORT MODE appears in the title bar)

REV: 13G18

Leave a Reply

Your email address will not be published. Required fields are marked *