UW underwater connectors provide a plug-and-play interface for connection to NexSens SDL500 Submersible Data Loggers.

The SDL500 sensor bulkhead includes sensor connection ports identified as T, P1, P0, A and D.

 

SDL500 Sensor BH

Figure 1: SDL500 Sensor Bulkhead

 

T-Node FR sensors and strings can be connected to Ports P0, P1, T, or D. It is recommended to connect to port P1 or T to allow for power to be removed from the T-Node FR sensors between readings. If this is done, ensure Switch Power is setup correctly in iChart.

 

REV: 13H06

 

Leave a Reply

Your email address will not be published. Required fields are marked *