Updating RTU SD Card on an X2-CB Logger

Tools Required 9/16″ Socket Wrench Phillips-head Screw Driver Tweezers (recommended, not required)   1. Disconnect the 6-pin solar panel or UW-6 USB cable from the X2-CB SOLAR/COM port to remove power from the data logger. 2. [For CB-150, 450 buoys only] Remove the buoy’s solar tower to gain access to the data well. Remove the […]

Read More

Accessing a SDL-V2 SD Card

Caution!!!- Be sure to statically ground yourself prior to touching any of the electronics inside the SDL V2 logger or the SD card itself Tools Required: – 3/16″ Ball-Point Hex Driver (included in logger maintenance kit) -Phillips Screw Driver  Use the 3/16″ hex driver to remove the four screws on the bottom bulkhead of the SDL […]

Read More

Replacing the SD card on an iSIC-V2

Caution!!!- Be sure to statically ground yourself prior to touching any of the electronics inside the iSIC V2 logger or the SD card itself Tools Required: -9/16″ Socket Wrench -5/32″ Allen Wrench Remove the UW-6 and UW-8 (if Equipped) connectors from the base of the iSIC V2 housing. Remove the (4) 3/8-16 bolts securing the […]

Read More