Click the Application button in the Settings tab to toggle the Application Settings described below on or off as desired.

 

Application Settings menu in the Settings tab in WQSensors software

Figure 1: Application Settings menu in the Settings tab in WQSensors software

 

“Show introduction animation?”displays an introductory animation each time WQSensors software is started. Un-checking this box will disable animation.

“Remember last menu location?” – specifies whether the WQSensors software should reload the last menu opened each time WQSensors software is started. Un-checking this box will make the Sensors menu the default page. This feature is useful if a specific Library menu table or formula is used often.

“Convert Celsius to Fahrenheit?” – specifies whether to display temperature readings in Celsius or Fahrenheit. Un-checking this box will display all temperature readings in Fahrenheit.

“Show mV values” – displays mV readings from WQSensors in the Sensors tab. Un-checking this box will disable the display of mV values. Note that mV readings are not required to take measurements but are useful in determining the quality of sensor calibrations.

Changing Log Interval

The intervals at which the sensor logs data can be changed in the Software Logging Interval menu. Clicking the Interval button on the Settings menu displays the current log interval in seconds. To change the interval, enter a new value and click Apply. Refer to WQSensors Logging Data for more information.

 

REV: 13H31

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.