Data can be logged to the computer manually as single measurements or automatically at a user-defined interval.

To log a single data point, click on the left hand side of the Log button. The left side of the button will turn blue and a short animation with the letter L will display on the bottom left hand corner of the screen.

 

Click Left Hand Side of Log button to log single data point

Figure 1: Click left-hand side of Log button to log single data point

 

For automatic data collection, a log interval must be specified. This interval can be set by clicking the Interval button in the Settings menu. Data can be logged as often as once per second.

 

The log interval can be changed from the Settings menu by clicking the Interval button

Figure 2: Log interval can be changed from the Settings menu by clicking the Interval button

To start logging continuous measurements automatically at the user-defined interval, click on the right-hand side of the Log button. The entire button will turn blue and a short animation with the letter L will display on the bottom left hand corner of the screen.

 

Click right hand side of log button to automatically log data at user defined interval

Figure 3: Click right-hand side of Log button to automatically log data at user-defined intervals

REV: 13H09

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.