To calibrate Sensor Readings:

  1. Click on the Calibrate button
  2. Select the parameter reading to calibrate as shown below
  3. Enter the calibrated value
  4. Click the Calibrate button again to complete the change

A short animation with the letter C will display on the bottom left hand corner of the screen. Temperature and mV values cannot be calibrated (except for calibration of ORP). This calibration is stored on the sensor, which means that the sensor can be calibrated on one computer and still returned calibrated results no matter which computer it is used on.

calibrate sensor readings

Figure 1: Calibrating Sensor Readings

 

REV: 13H31

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.