If an update to iChart fails within iChart, try clearing the Internet Explorer cache and then updating again: 1. Open Internet Explorer. 2. Locate Internet Options. It may be located under a settings wheel or simply denoted as “Options” or “Internet Options”. 3. Open Internet Options and navigate to the General tab. 4. […]
An MS2 connector is used to supply power to an iSIC Data Logger. It has two openings – one for power and the other for ground. An MS2 connector can be found on the A11 float charger (power adapter) and the solar panels of iSIC MAST systems. The port which connects the MS2 connector […]
The Basics FTP is a TCP based service exclusively. There is no UDP component to FTP. FTP is an unusual service in that it utilizes two ports, a ‘data’ port and a ‘command’ port (also known as the control port). Traditionally these are port 21 for the command port and port 20 for the data […]
Changing the data logger clock to match a different time zone is done by editing the Time Zone offset value and then syncing the logger’s clock to the PC clock. Open iChart with the current project file Click Edit | Preferences Under the Time section enter the appropriate number of seconds in the Time Zone offset box. Click OK Click on […]
The molarity of a solution is the number of moles of solute per liter of solution. The molar mass of any particle (atom, molecule, formula, or ion) is the sum of the average atomic masses of all atoms forming that particle. This is also known as molecular weight. The molar mass of an atom is […]
The Tritech Micron EchoSounder DST is an ultra-compact sonar altimeter with versatile communication options, making it compatible with a wide range of products. Upon ordering the Tritech Micron EchoSounder DST, Tritech will request a desired communication configuration. Information for determining the best configuration for use with a NexSens monitoring system is below. Communication: RS-232 or RS-485. […]
The common mode voltage range that the iSIC data logger can handle is 0-2.5V. A differential voltage, even though the difference is within the range of 0-2.5V, still may have individual voltages less than 0V or exceeding 2.5V. In this case, the signal is cut off at 0V or 2.5V which causes a faulty reading. […]
The 12V DC (direct current) batteries used on NexSens iSIC data loggers can be charged in two ways: online or offline. It will be necessary to decide which is most appropriate for the desired application. The necessary charger type can then be determined. Online Charging: If it is essential for the iSIC to always remain powered, […]
The LED only flashes when the iSIC is booting up and does not stay on all the time in order to conserve battery power. The LED will flash immediately upon connecting the battery but only for 15-20 seconds. REV: 13G29
Serial numbers for micro-T software are generated based on a signature unique to each computer and user. The registration key is then generated based on that serial number. The serial number and registration key must match for the software to work. Since signatures for a lab computer and an office computer are different, one registration […]
