Manually Update a Sensor Script File

Caution!!!- Be sure to statically ground yourself prior to touching any of the electronics inside the X2 logger

 

Instructions

    1. Remove Power from the X2 by disconnecting any cable connected to the center 6-pin port.

 

    1. Locate the green plastic wire from its track in the base of the X2’s aluminum housing.

 

    1. Slide tweezers or the tip of the screwdriver packaged with the X2 beneath the wire to expose it.

 

    1. Pull the end of the wire while applying pressure to the top of the X2 to remove it from the track. Tweezers or needle-nose pliers can be used if needed. 

 

    1. Pull up on the enclosure to separate it from the X2 base.

 

    1. Locate the X2 Main-PCB’s SD card, located on the top board

      X2 Main-PCB micro-SD Card Location

       

    2. Push the SD card further into the mount to unlock it. Place the card into a micro-SD card reader to access its files.

 

    1. Copy over the NexSens-supplied .lua file into the scripts folder and overwrite the existing file (if necessary).

      X2 Main-PCB SD Card Files

      Main Board X2 Script Folder

       

    2.  Copy over the provided DevLib.bin (where required) to the SYSCONF folder and overwrite the original.

      SYSCONF folder

      Replace the DevLib.bin file in the SYSCONF folder.

 

    1. Once the file modification(s) are complete, select the Eject option in Windows to safely remove the SD card.

      Eject the SD card in Windows.

       

    2. Re-install the SD card back into the slot on the X2’s Main PCB.

 

    1. Slide the enclosure back over top the X2 base, ensuring that no wires are pinched.

 

    1. Align the wire entry with the machined body tag on the aluminum base.

 

  1. Push down on the top of the enclosure and feed the wire back into its track and re-apply power to the system.