Cellular data accounts must be provisioned properly to work with NexSens data loggers. To ensure the account will be set up correctly, notify AT&T of all general account requirements during the initial account setup.

Figure 1: Sierra Wireless AirLink Raven RV50

Figure 1: Sierra Wireless AirLink Raven RV50

 

Cellular Coverage

AT&T must offer good coverage in the area of deployment. Use the link to check the coverage area: www.wireless.att.com/coverageviewer

AT&T Specific Requirements

  1. Contact NexSens to obtain the cellular modem IMEI number.
  2. Contact AT&T and request a new account. Ask for these (4) general account requirements:
  • Unrestricted Access
  • Static Public IP Address
  • Mobile-Terminated
  • i2gold Access Point Name (APN)

A SIM card must be installed in the cellular modem for AT&T accounts. SIM cards can be sent to the user, a local AT&T retailer, or directly to NexSens (preferred method). Typically NexSens handles SIM card installations.

att-4g-sim

Figure 1: AT&T 4G SIM

 

3. Contact NexSens to confirm the account is activated and send SIM card for final installation.

NOTE: All cellular iSIC data loggers should be activated, configured, and tested by NexSens to ensure quick startup in the field. After following the appropriate steps outlined above, keep in contact with NexSens about account updates, issues, and concerns in order to guarantee prompt shipment.

For modems not provisioned by NexSens, the correct modem template must be written, and the SIM card must be user installed. Follow the instructions at the links below:

Writing a Template to a Modem

For more information, see the 3100-iSIC and 3200-iSIC sections.

 

REV: 14A28

Leave a Reply

Your email address will not be published. Required fields are marked *