Setup X2 for Wi-Fi Transmission

    To connect a X2 data logger to a Wireless Network for data upload to WQData LIVE: Cycle 12V power to the X2 or cycle power on the X2’s Wi-Fi by placing the magnetic tip of the included screwdriver into one of the recesses on top of the device. With a laptop or mobile phone, look […]

    Read More

    X2 Wi-Fi Modes

    The X2’s Wi-Fi operates in either access point or network mode. Access Point Mode In access point mode, the X2 operates using a point to point configuration with a Wi-Fi capable device such as a smartphone, tablet, or laptop. The embedded web can be directly accessed by choosing it from the list of available Wi-Fi networks and […]

    Read More

    X2 Embedded Web

    The X2 has an embedded website that allows users to connect their Wi-Fi enabled device directly to the X2 without the need for an external internet connection. The embedded website is typically used during setup and diagnostics to take sensor readings and configure the data logger. To begin using the X2 Embedded Web, please Connect to […]

    Read More

    Connect an X2 to a Wi-Fi Network

    Connecting the X2 to an existing Wi-Fi network with an internet connection allows the device to constantly send live data to users. Configure Through Embedded Web Connect directly to the X2 logger’s embedded web Go to the Wi-Fi configuration page Enter the network credentials for the desired Wi-Fi network A static IP address is not […]

    Read More

    Connect to X2 Embedded Web

    The first step required when interfacing with the X2 directly over Wi-Fi is to establish a connection. Enable the Wi-Fi module on the X2 by using a magnet to wake it up (not available on X2-CB variant) or cycling power to the logger (Unplug the UW-6 power connector, wait 10 seconds, and re-connect) On the […]

    Read More