X2 Power Input

    The X2 has very flexible power input options that provide several options in terms of type and number of power sources. Basic Requirements Supply Voltage: 5-24VDC [+/-15%] Typical Running Current: 30mA @ 12V Operating Current Max (Wi-Fi and Telemetry Enabled): 350mA @ 12V Peak Current: 500mA @ 12V for 1 second Input Channels The X2 […]

    Read More

    X2-CB Power Input

    The X2-CB has an innovative power design that allows for simple connectivity and interfacing with NexSens CB-Series buoys. Power Jumper CB-Series solar towers have a special UW-6 plug with a jumper built in that completes the circuitĀ for the battery to supply power to the X2-CB data logger. The X2-CB will not receive power unless the […]

    Read More

    Replace an SP6 Battery

    Every couple years (2-3) an SP6 battery should be replaced in order to ensure reliable power delivery. Disconnect the UW-6 pigtail cable from the logger Remove the SP6 from its mounting location and place on a flat work surface Typically the easiest means of removing the SP6 is to remove both 1/4-20 x 1-1/2″ socket […]

    Read More

    SP6 Solar Power Pack Maintenance

    The only required maintenance for the SP6 Solar Power Pack are the following items. Clean the solar panel surface if it becomes covered Even small obstructions can have a significant impact on power output Ensure the vent is clear to prevent pressure buildup Replace the solar pack’s rechargeable battery every 2-3 years

    Read More