Configuring APG PT-500 Pressure Transducer

    The Modbus address and zero calibration of the APG PT-500 submersible pressure transducer can be set in iChart using the following process: 1. Go to Advanced | Sensor Interface | APG PT-500 to access the APG PT-500 Setup menu.   2. Enter the iSIC/SDL500 data logger communication settings and the Modbus address of the PT-500. The default Modbus address […]

    Read More

    Using iChart to Set APG PT-500 Zero Calibration

    The zero calibration of the APG PT-500 submersible pressure transducer can be set in iChart using the following process: 1. Go to Advanced | Sensor Interface | APG PT-500 to access the APG PT-500 Setup menu.   2. Enter the iSIC/SDL500 data logger communication settings and the Modbus address of the PT-500. The default Modbus address is 1 unless otherwise […]

    Read More

    APG PT-500 Submersible Pressure Transducer

    Instructions for interfacing the APG PT-500 Submersible Pressure Transducer with a NexSens iSIC data logger. IMPORTANT: Review the manufacturer’s manual for the sensor to ensure that the sensor is properly configured for integration with a third party data logger prior to connecting the device to the iSIC.  1. Route cables and wires through one of the […]

    Read More